Aqua Products IN GROUND ROBOTIC SWIMMING POOL CLEANER Troubleshooting Guide download pdf (Page 10)

Up & Down

arrow buttons

Red “ON” LED

Digital timer

display

Green LED

Continuous Run

(CRUN) button

RESET button

CONTINUOUS OPERATION

Press the C-RUN button, both the green LED above the C-RUN

button and the Red “ON” LED will illuminate.

The Cleaner will now clean your pool until you stop it by

switching the Power Supply Switch to the “OFF” position.

TIMED OPERATION

You can control the length of the forwards / reverse movement

time of your cleaner by using the control pad on the Power

Supply. Press the “UP” arrow button once for each second of

operation you desire (up to 90 seconds). The optimal amount of

time to set your cleaner’s movements is so that it reaches the

furthest edge, waits for several seconds and then reverses. As

your cleaner’s internal Filter becomes saturated with dirt the

amount of ﬂow coming through it will be reduced and thus your

cleaner will require more time to cross the pool. By the end of

its cleaning cycle it may only spend about 1 second every time

it reaches the pool’s edge. When you have selected the proper

number of seconds, press the RESET button to set the cleaning

time.

NOTE: You may add or subtract seconds by simply pressing the

“UP” or “DOWN” arrow button. This may be done while the

cleaner is in operation.

NOTE: The Power Supply will shut down and restart every eight

minutes. This feature will help keep the cleaner from becoming

stuck in the pool.

Set the operating mode for your cleaner after the cleaner has been placed in the pool, the Floating Cable from

the cleaner has been plugged in to the Power Supply and the Power Supply has been plugged into a GFCI /

R.C.D. protected electrical outlet.

The Power Supply should be placed in a sheltered area, at least 12 feet / 4 meters away from the pool. While

the Power Supply is weather-resistant, it is not waterproof and therefore it should be placed in an elevated

area where it will not sit in puddles of water.

Operating instructions for the Digital Timer (90 second / 7 Hour) Setting for an External Timer.

“90 second” timer:

Please make sure that the Power Supply is turned OFF and plugged into a properly grounded GFCI / R.C.D. 1.

outlet.

Turn the Power Switch ON and wait a few seconds until “- -“ keeps blinking on the display.2.

Make sure that the GREEN light above the C-RUN button is not blinking. If it is blinking then the timer is 3.

already set to the external timer mode. If it is not blinking then proceed to the next step.

Push and release the C-RUN button once. This should light up the GREEN light.4.

After this press and hold the C-RUN button for about 5-6 seconds until the GREEN light starts to blink. Now, 5.

the timer has been set to the external timer mode. Make sure that the Power Switch is on the ON position AT

ALL TIMES.

In order to reset the Power Supply back to the on-board timer mode, turn the Power Switch ON (if it is turned 6.

OFF) and wait till the GREEN light is blinking.

Now, press and hold the C-RUN button for about 5-6 seconds until the GREEN light stops blinking and 7.

remains OFF. Now, the timer has been set to the on-board timer mode.

EXTERNAL TIMER OPERATION

The size of your pool, and the amount of debris in it, will determine the length of time required to clean the pool.

The time required may vary up to two hours.

SETTING A DIGITAL TIMER...

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17

Comments to this Manuals

No comments

Aqua Products IN GROUND ROBOTIC SWIMMING POOL CLEANER Troubleshooting Guide Page 10

Comments to this Manuals

Related products and manuals for Above ground pool accessories Aqua Products IN GROUND ROBOTIC SWIMMING POOL CLEANER