PRODUCT SETTINGS and TROUBLESHOOTING
WARNINGS
DESCRIPTIVE TROUBLESHOOTING
ISSUE RECOMMENDED SOLUTION
Moves slowly or doesn’t seam to be vacuuming
• This is the most common question. The solution is to make sure that the filter bag is
thoroughly clean
• Check to see that the suction ports are not clogged or blocked
All LED lights are blinking on the power supply
• Check to see if the unit is out of water
• Check to see if the filter bag is stuck in the screen
• Check to see if the propellers are stuck
• To restart, press the power button once. Cleaning program will resume from where it
left off.
The Floating Cable is coiled up
• Change the axle set-up. Unit is most likely turning too sharply. Use the E-Z Swivel to
straighten out the cable
My unit is not sucking up debris
• Check to see that you’ve properly set-up the unit and power supply
• Check to see if the propellers are stuck
• Adjust the suction ports on the bottom of the unit
Unit is stuck in the middle of the pool but the unit
still pumps out water
• Check to see that there is nothing obstructing the cleaner or that the cleaner is not
stuck on any loose objects in the pool.
• The suction ports are far too low to the pool bottom. Adjust as necessary.
My cleaner looks like it is moving in the same
area of the pool and does not clean other areas
• Change the axle set up by adjusting the pin configuration. This will help move the
cleaner in a different direction to cleaner
• Check axle and turning pin configurations
Does not cover the entire pool
• Check to see that the filter bag is thoroughly clean
• Adjust the timing cycle on the power supply
• Check to see that the axle area is not clogged
• Check axle and turning pin configurations
This guide provides descriptive troubleshooting for this unit.
Should you need help with an issue that is not described in this manual, please the number below.
CALL CUSTOMER SERVICE AT 800-221-1750
You may also download the Quick Start Guide as well as the Settings and Troubleshooting Manual at: www.Aquabot.com
WARNING: Do not turn the Power Supply on, unless the pool cleaner is in
the water.
WARNING: Do not operate your machine while people swim in the pool.
WARNING: The Power Supply must be placed at least 12 feet / 4 meters
from the pool’s edge at all times! See diagram below.
WARNING: To prevent possible electric shock hazard this unit must be
connected to an RCD (Residual Current Device) with a related residual
operating current not exceeding 30mA.
WARNING: Before performing any troubleshooting maintenance
procedures, your Cleaner should be disconnected from the Power Supply
(transformer) and the Power Supply should be unplugged from the electrical
outlet to prevent the possibility of personal injury or damage to your Cleaner!
(16 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals